DIY: How to Sew With Satin Blanket Binding

How to Sew On Satin Edging at Creativebug

This is a guest post from Blair Stocker of Wise Craft Handmade.

How to Sew With Satin Blanket Binding

How to Sew On Satin Edging at Creativebug

I realize that is a picture of a blanket. In summer. But before you go running to the air conditioner vent, bear with me.

I have a habit of making wintery things during summer. Unexplainable, really, but I doubt I’m the only one. I recently made my first trip to Britex Fabrics in San Francisco (if you’ve been there, I am sharing a wide-eyed, nodding look with you right now). I found a beautiful piece of wool/poly blend fabric that I wanted to make it into some sort of blanket. A blanket for a getaway cabin I don’t actually own, but that’s another subject all together. Why wait for winter when I can get this project out of the way now, and share my love of pre-made satin blanket binding and how to sew with you?

How to Sew On Satin Edging at Creativebug

Satin blanket binding can be found at most big box craft stores, usually displayed with the zippers and thread. It comes in pre-cut packages like the one in the photo above, 4 3/4 yds, single folded (measures 2″ wide folded). It’s meant to be sandwiched around the edge of your chosen blanket material, to finish it off. In my case, it’s this large piece of wool, but you can use anything… minky fabric, a thick knit, terry cloth, sweatshirt knit, polar fleece, you name it. (Note for upcyclers- I often see large wool remnants at the thrift store that would be perfect to turn into a blanket after a good dry cleaning.) This binding could even be used as a wide quilt binding. Lots of possibilities.



How to Sew On Satin Edging at Creativebug

  • Blanket Fabric (For reference, my fabric was 61″ wide, and I purchased 2 yards, so about 60″ x 70″)
  • Prepackaged satin blanket binding. To determine how much you need, add length of all 4 sides together and add 10″. (I needed 2 packages.)
  • Fabric scissors or cutting mat and rotary cutter
  • Quilter’s ruler (3″ x 20″ is a good size, but any long, straight edge will do)
  • Sewing machine that can sew a zigzag stitch.
  • Satin blanket binding in a coordinating color.
  • Binder clips
  • Straight pins
  • Hand sewing needle

Step One:

Trim a straight edge on the cut edge sides (the selvedge edges are fine as is).

How to Sew On Satin Edging at Creativebug

Step Two:

The binding has one edge that is 1/4″ shorter than the other (see below). The shorter edge is the one that should face up when you sew, and will be on the right side of your blanket.

How to Sew On Satin Edging at Creativebug

Open up the binding and, starting around the midway point of one long side, sandwich the edge of the blanket in the binding. Make sure you are getting the blanket edging all the way to the inside fold. I find binder clips are helpful to hold things in place. Do this all the way down the side, stopping a few inches from the corner.

How to Sew On Satin Edging at Creativebug

How to Sew On Satin Edging at Creativebug

Step Three:

Set up your sewing machine for a wide zigzag stitch. I set the width on my Bernina to 4.25 with a normal stitch length. (Practice on a scrap piece if you need to.) Begin sewing right at the beginning of the binding, and let your zigzag stitches straddle the edge of the binding facing up. Because you did a good job of sandwiching the binding evenly, you will be catching/stitching along the other bottom edge that you can’t see. (Don’t worry, it’s easier than it sounds.)

How to Sew On Satin Edging at Creativebug

Step Four:

When you get a few inches away from a corner, you’ll need to stop and create a mitered fold. You can either leave the needle down in the fabric and do it at the machine, or secure with a backstitch and remove from under the machine, for easier folding. Open up the binding at the corner and position it as shown below-

How to Sew On Satin Edging at Creativebug

Fold the binding back over the edge of the next side you’ll sew, creating a mitered corner at the corner, like below. The fold should be the same, but going in the opposite direction on the back. Secure in place with binder clips or pins, and continue stitching.

How to Sew On Satin Edging at Creativebug

Step Five:

To add in a new piece of binding, simply clip it into place as pictured below, 1″ or so over the previous edge, and continue to sew on.

How to Sew On Satin Edging at Creativebug

Step Six:

I like to add a few slip stitches at the folded corners and where the new binding joins with the old, just to keep everything secure.

You’re done!


How to Sew On Satin Edging at Creativebug


Recommended Articles


  1. Great instructions. I’ve been putting this off because I was unsure about how to put on the binding so it looked nice. Your instructions are clear and easy to follow. I know I can do it now. Thanks so much.

  2. Thanks for the excellent instructions and photos. I was not clear on how to do the corners based on what I’d read from others…could be because I’m an amateur and this is my first time trying to put on binding. Anyway, you have helped me complete my project. Many thanks!

  3. Thank you a lot for sharing this with all people
    you really understand what you’re speaking approximately!

    Bookmarked. Kindly also discuss with my site =). We can have a hyperlink change arrangement among us

  4. An interesting discussion is worth comment. I think that you should write more on this topic, it might not be a taboo subject but generally people are not enough to speak on such topics. To the next. Cheers

  5. Hey there, You’ve done a fantastic job. I’ll definitely dig it and personally suggest to my friends. I am sure they’ll be benefited from this site.

  6. Aw, this was a really nice post. In idea I would like to put in writing like this additionally ? taking time and actual effort to make a very good article? but what can I say? I procrastinate alot and by no means seem to get something done.

  7. I?d have to check with you here. Which is not something I usually do! I enjoy reading a post that will make people think. Also, thanks for allowing me to comment!

  8. This design is wicked! You certainly know how to keep a reader amused.
    Between your wit and your videos, I was almost moved to start my
    own blog (well, almost…HaHa!) Wonderful job. I really loved what you had to say, and more than that, how you presented it.
    Too cool!

  9. I just couldn’t go away your web site before suggesting that I actually loved the usual info an individual supply to your guests?

    Is gonna be again incessantly in order to check up on new posts

  10. I think that is among the such a lot significant information for me.
    And i’m glad reading your article. But should remark on few general things, The website taste
    is ideal, the articles is in point of fact excellent : D.

    Excellent activity, cheers

Leave a Reply to Gardiner Gabe Cancel reply

Your email address will not be published.